3DAlienWorlds BLOG

First section of castle walls printed

Work continues on the samurai castle walls set, and the first section has been successfully test printed!



£ With framework based on the popular Necrontyr modular hills sci-fi set, this will be the straight section of the walls. It's 120mm x 120mm wide, with a base height of 75mm (slightly taller than two human-sized models). The 40mm wall on top makes for a very intimidating obstacle!

£ Here's the view from on top. The arrow slits are slightly tilted down, allowing defenders to fire down on attackers.

£ The floor surface has a light textured surface, which can be used for soil or grass with a quick drybrush. Sorry - it's not easy to see in this photo, but should look fine after a rough sanding.

£ ... or, if you want to go for a smooth surface, the floor can be flipped over instead.

£ This is our local Kokura castle, and shows the aged rock pattern I was aiming for. Weathered, mossy rocks make for more interesting wargaming terrain and give great options for paint, I think.

Name
Comments
Enter Code