3d-printable terrain for all your samurai wargaming needs
| << Designing some rooftile panels 2021-08-18 | Customer pics! >> 2021-08-26 |
We have a new preview to show you today - the Dicetower Pagoda for our samurai range!
£ As you can see, this model is an alternate version of the large 5-level Temple Pagoda tower. The walls of each level have been changed from wood to stucco, but the roof sections remain mostly the same, although edited to provide an internal dice tower structure.
The middle section of the top roof simply lifts out to reveal a dice bucket, into which you can pour your dice. The dice then bounce down the centre of the dicetower....
£ ... and out of the front door, down the steps and finish in this fenced area!
You could use this tower without the base section if you like, but it also features this neat little stone and wood base, modelled after the actual pagoda tower at Ruriko Temple in Yamaguchi.
The low bamboo fence is removable (for easier transport and storage), and can be slotted into place around the steps. There is a 30mm-wide gap at the front of the fence for models to access the front steps of the tower, but you could also place extra bamboo pieces (included in the set) across if you want a more complete fence.
There's a new 3D printer on its way here soon (Ender 3 V2), and this will be one of the first designs to roll off it! Watch this space!
| << Designing some rooftile panels 2021-08-18 | Customer pics! >> 2021-08-26 |
Blog
