3DAlienWorlds BLOG

Printing the Exodite Hut

Whoa... this was a BIG print! I chose to print this new Eldari model at 0.1mm layers, and it took a loooong time! I'd probably recommend trying it at 0.2mm layers instead, but my printer's been acting up a bit recently :(

Anyway, here is the printed Eldari Exodite Hut, ready for the paint desk.....




The dome is printed in 4 parts, and supports are only needed for those two 'horns' at the front.

The landing pad part is printed in two sections, and simply glued together. I'm not going to glue this yet, as I think painting those gems will need full access to the underside of the pad.

Finally, you need to print 5 of these spires to go around the outside of the landing pad. They have been split into two halves, and a small amount of supports are required.

Here's the completed building, with a Dark Reaper for scale.

Hopefully I can get this painted up and available for download by the end of the week!

Name
Comments
Enter Code